POV Remote
The POV Remote uses radio signals to control the record, tag, and stop functions. The POV Recording Unit does not require the POV Remote, and multiple recording units can be controlled by one remote. There are a total of 10 available ID channels that you can use to allow multiple POV.1.5’s with one remote, or use multiple remote controls in close proximity without interference. To replace the battery, or to change the channel ID of your POV Remote please use the following instructions:
To open the POV Remote Control
- Place the remote unit on a flat surface with the buttons facing up.
- Unscrew the four small Phillips screws in each corner and lift the cover from the remote. Take care to protect the inside of the remote control unit from dust and moisture while the cover is removed.
- After changing the battery, replace the cover, tightening the four screws uniformly to create even pressure against the seal.
To change the POV Remote channel I.D. (On the Remote Control)
The REMOTE I.D. channel of the wireless remote control is set using a small rotary dial located inside the remote control. To adjust the channel ID
POV Remote with the cover removed
Note: The channel ID on the POV Remote and the POV Recording Unit must set to the same channel in order for the POV Remote to function correctly.
To change the REMOTE I.D. channel of the POV.1.5 Recorder:
- Press the SETTINGS button
- Press the PREV or NXT soft keys until REMOTE I.D. is shown in the display and press SELECT
- Press PREV or NXT until the desired channel is displayed and press the SELECT soft key to choose that channel.